VT800 / Monitoring unit (legacy)

Owned by Vladimir Tayzhev
Last updated: Feb 22, 2024
2 min read

 

 


1. "SMA" - connector, used when the GSM modem is installed inside of the appliance to connect the GSM antenna.

2. "LAN" - Ethernet 10/100 Base-T port, provides an Ethernet connection.

• LEDs - "yellow" (status) and "green" (traffic) show the network traffic. The status LED: flashes green when the system starts up, and shows the connection state (constant green light - the connection is established, blinking green - the connection attempt).

3. "USB" - type A USB-port 2.0, is required for a USB flash drive to upgrade an appliance.

4. LED: "ACT" - indicates GSM SIM card status

5. "HS USB" - type miniAB USB-port 2.0, required to connect a USB camera or to restore an appliance.

6. "SIM" - connector with an ejector, used when a GSM modem is installed inside of the appliance to connect a SIM card. “VT920 / GSM modem” is purchased separately. Read more at VT920 / GSM modem (legacy)

7. "SD" - SD, MicroSD card connector with ejector, needed to store data.

8. "Reset" - resets the appliance.

9. LEDs: "ACT" - indicates appliance status, "CN1" - indicates CAN1 bus traffic, "CN2" - indicates CAN2 bus traffic, "ERR" - indicates error and traffic.

• Blinking "ACT" ............ • Blinking "CN1" ............ • Blinking "CN2"............ • Blinking "ERR»" ..........

10. "CAN" - two equivalent digital connectors RJ12 for the connection of CAN sensors and CAN extensions on a CAN bus, with auto-sensing.

11. "A1..A8" - 8 RJ12 analog sensor inputs with auto-sensing.

12. "Reader" - RJ9 connector for IButton reader or for RFID reader with 1-Wire.

13. "DC 12V 2A" - DC power input.

14. "Dry contacts" - empty slot for dry contacts module VT16, used to connect dry contacts on doors, windows, etc.

15. "Sticker" - Place a sticker that can be written on. For example: you can write an IP address of the master module.

16.  "S/N" - serial number. You will need this serial number if you want to contact our support team. It is important that you do not lose it!

17. "Dip switch" Normal ↑ Off - the system should be always switched to this mode.

Recovery ↓ On - use this option only in case you need to recover manufacturing settings.

18. "" Grounding.

 

Developer notes: metal case v.17.2