Connecting "VT10 / 1-Wire board"

Read articles: Connecting 1-Wire devices and VT10 / 1-Wire board

Setting up 1-Wire inside user interface

After "VT10 / 1-Wire board" has been installed inside the system, a new system group should appear inside monitoring unit's user interface: System tree >> System group>> "1wire".

1-Wire bus should have "Initial state"switched to "On". In such a case all the 1-Wire sensors connected to "VT10"should appear inside unit's system tree. On the picture above we see that 1-Wire temperature sensor is connected to the 1-Wire bus.

Configuration of 1-Wire sensors is identical to the configuration of analog sensors. Please, read article for further info: Sensor configuration