Versions Compared

Old Version 17

changes.mady.by.user Vladimir Tayzhev

Saved on

compared with

New Version Current

changes.mady.by.user Vladimir Tayzhev

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Connect the sensor's x2 cables to the 3.5mm power terminal connector as shown in the picture below. Cables may be swapped.

  2. Insert the terminal into the "Dry contact Input" of the Vutlan monitoring system.

  3. Image RemovedImage Added

Installation/mounting

1

Image RemovedImage Added

  1. Mount the "Magnet" (which does not have wires) on the door or window using the sticker or two screws supplied in the package.

  2. Mount the "Sensing element" (which has two wires) on the door or window frame.

2

Image RemovedImage Added

  1. Make sure to align the sensors to each other.

  2. Make sure to turn them to each other as displayed in the picture.

  3. The distance between the magnet and the sensing element should not exceed 8-10mm.

3

Image RemovedImage Added

  1. When the door is closed, the contact is closed. By default, the sensor is in a normal state. The initial state of the sensor can be changed in the web interface.

4

Image RemovedImage Added

  1. When the door is open, the contact is closed. By default, the sensor goes to an alarm state. The initial state of the sensor can be changed in the web interface.

...