...
The software allows you to backup the settings of the monitoring unit in a file, as well as restore thebacup the backup settings and reset them by default.
...
Since v. 2.7.1 is available selective backup settings to a file.
Selective The selective backup configuration file can be used for mass deployment of monitoring units on a facilities facility when it is expected to use multiple units with identical settings. One monitoring system is set up first , after which the settings of this system are necessary to backupback up. Further backup settings are restored on other systems, and different parameters are set manually.
Backup settings
To backup back up the current settings to a file, in the System interface go to tab -> "System menu" -> "Export" and push-button "OK" for "Download current settings"
| Info |
|---|
 Please note that before the operation it is necessary to save sensor settings. Push "Save to Flash" in the upper right corner! |
Backup settings on the
...
FTP server on a schedule.
To configure the backup settings on the ftp FTP server on a schedule, go to Preferences-> FTP Backup
...
| # | Field | Definition |
|---|---|---|
| 1 | FTP Server | FTP server address |
| 2 | FTP port | FTP server port |
| 3 | Username | FTP server user |
| 4 | Password | The user's password on the FTP server |
| 5 | Target directory | Directory to save the settings on the FTP server (would be there!) |
| 6 | Execution interval | Backup settings range. Possible values:
|
| 7 | Day of backup | Day of the week or of month |
| 8 | Time of backup | Backup time |
...
Reset firmware installed in the same way like a usual software upgrade.
2) in a Web interface:
Starting with version 2.5.0 reset is also possible via the web interface. Go to the tab "System menu" ->About and push tab "OK" for "Reset settings to default values"
...
To return to factory settings, set the switch NORMAL / RECOVERY in the "RECOVERY" position for a time of 5 to 30 seconds.
In 5 s after turning this switch to the "RECOVERY" position, the "ERROR" LED on the front panel lights Upup. Now return the switch NORMAL / RECOVERY in the "NORMAL" position. System restored The system restored the factory settings and then reboot.
If till 30 seconds after the ERROR LED lights up switch was not set to NORMAL, then the system will assume that the switch is set to "RECOVERY" by mistake. In this case, the LED starts to flash at a frequency of once per second, recalling this abnormal position of the switch. and even if now the switch is set to "NORMAL", the light goes out, but the restoration of the configuration and reboot does not occur.
If the switch stay stays in "RECOVERY" for less than 5 seconds (before LED lights up), the settings reset and restart will not be made.