All Vutlan monitoring systems and switched PDUs have the ability to connect up to two alarm beacons, for example, a siren and/or strobe, and other low-current devices, for example, a dry contact output module VT11, to E1, E2 - two outputs of electronic relays.
Connection
To connect the alarm beacon to the 12V output, you need to connect the device with a cable to the terminal according to the polarity. By appropriate logic or manually in the device interface, you can turn on or off and/or give a pulse to the siren, strobe, or a signal on a dry contact output. The maximum current consumption is limited by 250 mA.
Check the voltage supply in the test mode. Go to the Main Menu -> System Structure -> Alarm in the system interface. In the window that appears, click "Pulse". The stroboscope lights up, and the siren wails. To configure alarms, you need to configure the logic.
.jpg?version=1&modificationDate=1523611673801&cacheVersion=1&api=v2&width=250&height=363)
Do not connect the loads to the outputs while the monitoring system is on.
.jpg?version=1&modificationDate=1589873218275&cacheVersion=1&api=v2&width=800&height=385)