Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Current »



1. "LAN" - Ethernet 10/100 Base-T port, provides Ethernet connection.

• LEDs - "yellow" (status) and "green" (traffic) shows the network traffic. The status LED: flashes green when system starts up, shows the connection state (constant green light - the connection is established, blinking green - the connection attempt).

2. "HS USB" - type miniAB USB-port 2.0, required to connect a USB camera or to restore an appliance.

3. "A1..A4" - 4 RJ12 analog sensor inputs with auto-sensing.

4. LED: "ACT" - indicates GSM SIM card status

5. "RESTART" - restarts the appliance.

6. LEDs: "ACT" - indicates appliance status, "E1" - indicates 12V E1 relay status, "E2" - indicates 12V E2 relay status, "ERROR»" - indicates error and traffic.

7. "ANTENNA" - connector, used when GSM modem is installed inside of the appliance to connect GSM antenna.

8. "" Grounding.

9. "Dip switch" Normal ↑ Off - the system should be always switched to this mode.

Recovery ↓ On - use this option only in case you need to recover manufacturing settings.

10. "DRY CONTACTS 1...4" - Dry contacts terminal (type IN)

11. "SIM" - connector with an ejector, used when VT700 / GSM modem is installed inside of the appliance to connect SIM card (VT700 is ordered separately).

12. "OUTPUT 12V 0.25A" - 12V 0.25A output electronic relay teminal

13. "DC 12V 2A" - DC power input.



Developer notes: metal case v1.1

  • No labels