VT103 / Strobe light

Function and purpose

Package includes

Package content can be found at : VT105 package content

Connecting a strobe light using only a sticker

A strobe light can only be connected to 12V 0.25A outputs of the Vutlan monitoring system. The diagram below explains how to connect "VT105 / Strobe light" to a monitoring system.

Step 1.

Remove the central part of the sticker.

Step 2.

a) Remove the protective paper from one side of the sticker. Apply the sticker to the "VT105 / Stobe light" backside.

b) Remove the protective paper from the second side of the sticker. Stick the Strobe light together with the sticker to the surface. Make sure the cable is laid out neatly using the stickers holes.

Step 3.

Connect the cables to 12V 0.25A outputs of the monitoring unit using a Terminal. The terminal must have 3.81mm step.

a) Connect the black cable to a "-". Indicated by the "earth" sign.

b) Connect the red cable to a "+". Indicated by "E1" or "E2" label.

Connecting a strobe light using dowels

Step 1.

Remove hole parts of the sticker.

Step 2.

Screw the back panel to the back side of the strobe light using 2 M3 screws.

Step 3.

a) Drill two holes for the dowels.

b) Drill middle hole in the surface if You plan to wire cables through the surface.

Step 4.

a) Insert the dowels into the wall.

b) Insert the adhessive sticker between the wall and the back panel.

c) Screw two M3 screws through the back panel and sticker into the dowels.

Step 5.

Once one back panel is screwed to the wall and the other is screwed to the strobe light, connect both back panels together and rotate the strobe light until it is firmly connected.

Step 6.

Connect the wires to the monitoring unit.

12V relay configuration (alarm beacon or strobe light)

a) Login to the web interface of the monitoring system

b) To configure the relay: go to System tree >> Power 12V 0.25A >> Choose relay

c) By default Power-1 and Power-2. Rename it, set initial state and set Pulse duration time in seconds to specific time period.

Cable pinouts

Strobe light uses standard two wire cable for connecting to the monitoring unit.

Technical specifications

Developer notes: