Front panel of VT960 and VT960 DC:
...
VT960 back panel:
...
VT960 DC back panel:
...
1. "1U 19 inch brackets" - 2x pcs for mounting into a 1U 19" rack slot.
2. "Logo sticker" - Displays the article number of the monitoring unit.
...
4a. "Modem status" - displays modems modem status.
4b. "SIM card" - connector with an ejector, used when the modem is installed inside of the appliance.
4c. "GPS active antenna" - Connector, used when the modem is installed inside of the appliance to connect GPS antenna (GPS antenna and antenna output are ordered separately from the modem). (Currently not supported)
4d. "GSM, LTE main antenna" - Connector, used when the modem is installed inside of the appliance to connect GSM or LTE main antenna. (Main The main antenna is supplied together with the modem).
4e. "LTE auxiliary antenna" - Connector, used when the modem is installed inside of the appliance to connect LTE auxiliary antenna (Auxiliary LTE antenna and antenna output are ordered separately from the modem).
...
"CAN" glows constantly - connected to CAN devices
"LED: HDD»" - green LED indicates 2.5" HDD or SSD status.
"LED: ERR»" - red LED indicates error and traffic.
...
9. "USB 0" - type miniAB USB-port 2.0, required to connect a USB camera. (Restore of the appliance using USB is temporary temporarily unavailable)
10. "LAN" - Ethernet 10/100 Base-T port, provides an Ethernet connection.
• LEDs - "yellow" (status) and "green" (traffic) shows show the network traffic. The status LED: flashes green when the system starts up, and shows the connection state (constant green light - the connection is established, blinking green - the connection attempt).
...
12. "Restart" - restarts the appliance.
"FEL" - user-defined action button.
"Shutdown" - softly shuts down the device.
13. "USB 1" - type USB-port 2.0, required to connect a USB camera. (Restore of the appliance using USB is temporary temporarily unavailable)
14. "Extension board: VTX40a " - Ordered separately. Installed inside the unit. Adds: x32 Dry Contact inputs, x8 Isolated Dry Contact Outputs.
15. "
" - External chassis grounding, M4 thread.
...
18. "1-WIRE" - For connecting 1-Wire sensors. Serial A serial communication protocol that uses a single data line plus ground reference between the master and 1-Wire slave device.
...
20. "DC OUTPUT 12V 0.25A Camera PWR" - 12V 0.25A output electronic relay teminalterminal
21. "OUTPUTS 12V 0.25A" - 12V 0.25A output electronic relay terminals
...