The discrete output elements parameters of the VUTLAN devices can be located depending on their physical location in the sub-branches:
ctlInternalSensors - main system sensors;
ctlInternalSensorsOutletsTable;
ctlCANSensors - CAN bus sensors;
ctlCANSensorsOutletsTable;
ctlRsSensors - serial port sensors;
ctlRsSensorsOutletsTable;
Example. View outlets available in the system:
| Code Block |
|---|
$ snmptable -Ci -Cb -v2c -cread 192.168.0.193 VUTLAN-SYSTEM-MIB::ctlInternalSensorsOutletsTable |
| Code Block |
|---|
...
| linenumbers | true |
|---|
SNMP table: VUTLAN-SYSTEM-MIB::ctlInternalSensorsOutletsTable
Id Module Num Type Name State Value Initial Pulse
301001 2002 -1 "relay" "Analog Power" "on" "on" "on" 15
102001 2003 1 "outlet" "Relay-1" "off" "off" "off" 1
102002 2003 2 "outlet" "Relay-2" "off" "off" "off" 1
102003 2003 3 "outlet" "Relay-3" "off" "off" "off" 1
102004 2003 4 "outlet" "Relay-4" "off" "off" "off" 1 |
The location of the such elements in the system is determined by the module identifier in which this element is physically located and with the port number in the module - Num.
Relays (Outlets) may be in the following possible states:
'on' - switched on;
'off' - switched off;
'pulse' - pulse.
The initial state is given by the field Initial. Management of the state is recorded in the field Value. The pulse length in seconds is given by the field Pulse.
...
Example. Sending 5 seconds pulse on the the relay with ID=102003:
| Code Block | linenumbers | true
|---|
$ snmpset -v2c -cwrite 192.168.0.193 VUTLAN-SYSTEM-MIB::ctlOutletPulse.102003 i 5 \ VUTLAN-SYSTEM-MIB::ctlOutletValue.102003 s "pulse" VUTLAN-SYSTEM-MIB::ctlOutletPulse.102003 = INTEGER: 5 VUTLAN-SYSTEM-MIB::ctlOutletValue.102003 = STRING: "pulse" |