To update the software via USB, first upload appropriate driver from our "drivers" section.For versions
| Warning |
|---|
Attention! Use only one file when upgade! Second upgrade is possible only after system rebooted. |
To upgrade to version 2.5.0 and higher:
a) download first file named firmware-kernel.vut, then, for version 2.4.5 and higher You need to download a file named: firmware.vut.
You can use any of 3 files:
firmware.vut - upgrade
rename it into firmware.vut file and upgrade, for versions 2.4.4 and lower, rename it into sky25firmware.sky and upgrade. Wait until system rebooted.
b) download file named firmware.vut, for version 2.4.5 and higher use firmware.vut file and upgrade, for versions 2.4.4 and lower, rename it into sky25firmware.sky and upgrade.
For versions 2.4.5 and higher You can dowonlad and use a files named:
settings.vut -settings reset
resetusers.vut - users password reset
...
The process of updating will be displayed on the LED on the front panel of the device.
After The updating process is indicated by LEDs on the front panel of the device: file installation is indicated by switching ERR, the end of the installation process is indicated by a short-term increase in switching frequency ACT. Then all the lights switches off - the system is rebooted. Completion is indicated by switching reboot ACT.
After the reboot (all the LEDs will be are turned off) test after 30-60 seconds, check the system operation.