...
Inside the web interface of the system go to >> Preferences menu >> Network tab >> Enable CAN >> Save >> Save settings to flash (An icon in the top right corner of the web interface)
Configuration
CAN bus is used for connection of CAN sensors and CAN modules. The device has two independent CAN nodes: CAN1 and СAN2.
Before using CAN sensor module, CAN bus must be configured to operate with this CAN sensor module. To
To configure the CAN bus go to "Main menu" >> "CAN configuration" menu, which in turn has two identical tabs - one for each node.
Each station tab contains current information on the status of the node and a list of CAN sensor modules connected to this node.
...
If you need to remove CAN sensor module from the configuration list use command Delete, then use the command "Save" to apply the changes you made and restart the node using the command Restart.
...