View Source

Version 2.4.4 b104

Date of release: 24.02.2015

This version is designed to update the firmware of SC81xx / SC21xx / SC11xx of Sky Control.

Updates:

A few SMS number possibility included and test bug killed!
SC410 and SC 420 current and voltage sensors form corrected. Attention! NowSC410 sensor shows only 0-5V independently of measured value. (For example measured value 0-10V shows only 0-5V!)
Macros %8 for element identity in a group;
MicroSIM cards added;
Macros %8 for SNMP added;
Default values for Internal temperature and Voltage set up;
Floating menus
New users bug killed
Maps sensor place bug killed

Backup your current system settings before update to this version firmware to be able restore settings for possible downgrade later.

Since the authorization system changed, after the update does not saved the current user information. Please, use default account: guest:guest

The appliance has the possibility to update or to restore software. You can update software via HTTP, FTP or using USB flash drive. Installation instructions can be found here: English.

Drivers & Software > 2.4.2 > image2012-6-25 16-36-13.png

HTTP upgrade (SC series)

sky25firmware-2.4.4-b104.sky

sky25firmware-2.4.4-b104.md5

Drivers & Software > 2.4.2 > drivers_USB_s100.jpg

USB upgrade (SC series)

sky25firmware.sky

sky25firmware.md5

Drivers & Software > 2.4.2 > drivers_restore_s100.jpg

Firmware Recovery Tool (SC series)

skyupdater-2.4.4.zip

skyupdater-2.4.4.zip.md5

Drivers & Software > 2.4.2 > drivers_restore_s100.jpg

Settings Recovery Tools (SC series)

recovery_tools.zip

recovery_tools.zip.md5

Drivers & Software > 2.4.2 > drivers_restore_s100.jpg

Reset Password (SC series)

sky25resetusers.sky

sky25resetusers.sky.md5

If the type of your master-module does not match the master module in the firmware, please, setup the correct type of master module by means of a special procedure /wiki/spaces/DEN/pages/9502783 or /wiki/spaces/DocRU/pages/9502781

To allow us better support please leave your comments below or on our forum.

developer notes: linkchange