Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

1. "LAN" - Ethernet 10/100 Base-T port, provides an Ethernet connection.

• LEDs - "yellow" (status) and "green" (traffic) show the network traffic. The status LED: flashes green when the system starts up, and shows the connection state (constant green light - the connection is established, blinking green - the connection attempt).

2. "USB" - type A USB-port 2.0, is required for a USB flash drive to upgrade an appliance.

3. "HS" - type miniAB USB-port 2.0, required to connect a USB camera or to restore an appliance.

4. "Reset" - resets the appliance.

5. "SD" - SD card connector with ejector, needed to store data.

6. LEDs: "ACT" - indicates appliance status, "CN1" - indicates CAN1 bus traffic, "CN2" - indicates CAN2 bus traffic, and "ERR»" - indicates error and traffic.

• Blinking "ACT" ............ • Blinking "CN1" ............ • Blinking "CN2"............ • Blinking "ERR»" ..........

7. "CAN" - two equivalent digital connectors RJ12 for the connection of CAN sensors and CAN extensions on a CAN bus, with auto-sensing.

8. "TR" - labeled as "1" on this module. Needed for connection of CAN sensors.

9. "A1..A8" - 8 RJ12 analog sensor inputs with auto-sensing.

10. "SIM" - connector with an ejector, used when a GSM modem is installed inside of the appliance to connect a SIM card.

11. "Outputs 1..4" - 4 relays status indicators.

12. "1-Wire" - RJ9 connector for 1-Wire I-touch I-Button readers with auto-sensing or for Alarm Beakon / Siren connection.

13. "SMA" - connector, used when GSM modem is installed inside of the appliance to connect the GSM antenna.

  • No labels