| Warning |
|---|
The production and sales of the unit has been stopped. Read the EOL for more information at VT8101 End-of-Life Announcement |
VT8101 front and back panel
.jpg?version=1&modificationDate=1461314358367&cacheVersion=1&api=v2&width=700)
...
1. "LAN" - Ethernet 10/100 Base-T port, provides an Ethernet connection.
• LEDs - "yellow" (status) and "green" (traffic) shows show the network traffic. The status LED: flashes green when the system starts up, and shows the connection state (constant green light - the connection is established, blinking green - the connection attempt).
2. "USB" - type A USB-port 2.0, is required for a USB flash drive to upgrade an appliance.
...
6. LEDs: "ACT" - indicates appliance status, "CN1" - indicates CAN1 bus traffic, "CN2" - indicates CAN2 bus traffic, "ERR»" - indicates error and traffic.
...
10. "SIM" - connector with an ejector, used when a GSM modem is installed inside of the appliance to connect a SIM card.
11. "Output LEDs" - relays status indicators, "LED * " - Alarm status indicator
...
13. "SMA" - connector, used when the GSM modem is installed inside of the appliance to connect the GSM antenna.
14. "Sticker" - Place for a sticker that can be written on. For example: you can write an IP address of the master module.
15. "AC line" - power input 240V 10A. IEC C14 connector (AC 100-240 VAC, 50/60HZ).
16. "Fuse 2A" - type 5*20mm
17. "
" Grounding.
...
20. "Alarm" - 12V 0.2A output teminalterminal
21. "DC 12V" - backup power socket, to connect a battery or a power backup.
22. "Dry contacts" - empty slot for dry contacts module VT16, used to connect dry contacts on doors, windows, etсetc.
23. "Dip switch" Normal ↑ Off - the system should be always switched to this mode.
...