...
"VT107 / RFID reader" can be used for access control. It operates on a principle of contactless reading data from "VT108 / RFID cards". Each card (transponder) has a unique 40-bit identification number stored permanently (the
number is unique to each card/transponder). The reader sends this number using a 1-wire bus in a format compatible with Vutlan monitoring systems.
Can be used together with all Vutlan monitoring units.
Requires "VT10 / 1-Wire extension" for VT325, VT335, VT335 DC, VT335 S, VT805, VT825, VT825 DC in order to be installed. Only one reader can be connected to one monitoring system.
"VT108 / RFID cards" are purchased separately.
Pinout
# on reader | Description |
|---|---|
| 1 | VCC ( + ) |
| 2 | GND ( – ) |
| 3 | 1-WIRE |
| 4 | Input Power LED red LED’a |
| 5 | Not used (red led) |
| 6 | Green LED (indicates power) |
| 7 | Button (it includes a bus 1-Wire to ground) |
Dimensions
The hole size for the screws is 4mm in diameter.
...
Step 2.
- Drill holes on the mounted mounting surface (e.g. wall). Holes for plastic dowels and for the RJ9 cable to go through.
- Insert plastic dowels into drilled holes of the surface.
- Carry RJ9 cable through the drilled hole.
Connected RJ9(4P4C) cable to "VT10 / 1-Wire extension" on the monitoring system. The reader is determined automatically. Once the reader is connected, You should hear a "BeapBeep!" sound.
- Place a sticker on the RFID reader.
Configuration
...
Edit name of the element. For example : RFID reader. By default iButton/Reader has a state: not connected.
...
If "VT108 / RFID card " is used and it is not accepted. The Current state changes to "Alarm" and then back to "Not connected".
Step 2. Inside of In the system's web interface go to the "Access control" menu.
Step 3. Press the "+" sign to add a new user and their electronic key. A modal window "Add a new key" will open.
Step 4.Press the "Read" button. You will be prompted with a request:
...
Step 5. Place "VT108 / RFID card" of the user next to the front panel of the reader. You will hear a "BeapBeep!" sound from the Vutlan monitoring system.
...
If "VT108 / RFID card " is used and it is not accepted. The Current state changes to "Alarm" and then back to "Not connected".
Then we can setup set up a simple logic. For example, we want to activate an electromagnetic lock if the correct RFID card is used. And open the lock using the Exit button using dry contact input. Picture The picture below shows such a logic example.
...