/
Routing

Routing

Contents

Introduction

Static routes are designed for traffic that should not pass through the default gateway. It can also be used to add some routes to link units to other networks in your company.

Configuration

Go to the "Routing" tab on the "Preferences" page. If static routes are required, they can be added to the routing table using the "ip route add" command. 

To add a static route to a host address, in other words to a single IP address, use the command:  ip route add 10.8.1.123 via 10.8.1.1

To add a static route to a network, in other words to an IP address representing a range of IP addresses, use the following command:  ip route add 192.168.1.0/24 via 192.168.0.115
Where 192.168.1.0 is the IP address of the destination network in dotted-decimal notation and /24 is the network prefix. The network prefix is the number of enabled bits in the subnet mask.
Where 192.168.0.115 is the address of the gateway, usually this is a router connecting two networks. 

Restart the unit for the changes to take effect. Each time the system starts, the specified commands apply. The log will show the set of new routes or errors if they occur.

Traceroute tool

Traceroute are network diagnostic tools for displaying possible routes (paths) and measuring transit delays of packets across a network. 

Enter the desired IP address in the "Address" field and click the "Start" button. If data receives a long time, then click "Refresh" to see current data. If you re-press the "Start", then the process of the traceroute restarts again.  

 

Related content

SSL-certificate installation
SSL-certificate installation
Read with this
Routing settings
Routing settings
More like this
Latest Vutlan drivers for VT855i series (VT335i, VT825i, VT855i)
Latest Vutlan drivers for VT855i series (VT335i, VT825i, VT855i)
Read with this
VPN Client
VPN Client
More like this
Latest Vutlan drivers for VT325, VT335S, VT336, VT604, VT608, VT805, VT825
Latest Vutlan drivers for VT325, VT335S, VT336, VT604, VT608, VT805, VT825
Read with this
Creating a PING element
Creating a PING element
More like this