...
To back up the current settings to a file, in the System interface go to tab -> "System menu" -> "Export" and push-button "OK" for "Download current settings"
| Info |
|---|
 Please note that before the operation it is necessary to save sensor settings. Push "Save to Flash" in the upper right corner! |
...
The following ways are possible:
1
...
. With a special firmware
This possibility exists in all versions. Factory data reset is carried out using special firmware that can be downloaded from the drivers as the Settings Recovery Tools.
...
Reset firmware installed in the same way as a usual software upgrade.
2
...
. In a Web interface
...
Go to the tab "System menu" ->About System menu → About and push tab button "OK" for "Reset settings to default values" .
...
Possible options:
for sensors - reset sensors (elements) only;
for all - resets all to factory settings;.
3
...
. Using a
...
"
...
From version 2.5.1 and higher added the ability to return factory settings using a switch NORMAL / RECOVERY.
To return to factory settings, set the switch NORMAL / RECOVERY in the "RECOVERY" position for a time of 5 to 30 seconds.
In 5 s after turning this switch to the "RECOVERY" position, the "ERROR" LED on the front panel lights up. Now return the switch NORMAL / RECOVERY in the "NORMAL" position. The system restored the factory settings and then rebooted.
If till 30 seconds after the ERROR LED lights up switch was not set to NORMAL, then the system will assume that the switch is set to "RECOVERY" by mistake. In this case, the LED starts to flash at a frequency of once per second, recalling this abnormal position of the switch. and even if the switch is set to "NORMAL", the light goes out, but the restoration of the configuration and reboot do not occur.
...
Factory reset" button
On some devices, this button may be labeled as “Reset”.
|
|
|
|---|
To restore the factory settings, press and hold the “Factory reset“ button. After 5-10 seconds, the Error LED (red) will start flashing. After that, you can release the button. The Error LED will light up continuously and the settings restore process will start. After that, the device will automatically reboot with default factory configuration.
If the button push for less than 5 seconds (before the Error LED lights upstart flashing), the settings reset , and a restart will not be made.