...
CAN bus is used for connection of CAN sensors and CAN modules. The device has two has two independent CAN nodes: CAN1 and СAN2.
Before using CAN sensor module, CAN bus must be configured in order to operate with this CAN sensor module. To configure CAN bus go to "Main menu" >> "CAN" menu, which in turn has two identical tabs - one for each node.
...
The following operations can be carried out on the CAN bus node:
- Refresh - updates the current information on the status of the node;
- Configure - launches configuration process of the nodes for CAN sensor modules connected to it, the old configuration is lost
- Save - saves the list of CAN sensor modules in flash memory;
- Restart - restarts the CAN bus node.
To delete a CAN sensor module, click on a the desired module. A modal window will pop up. Press "Delete" and confirm.
...
To set up a CAN bus node for operation with the CAN sensor module, connect CAN module to CAN network and run corresponding configuration procedure in the web - interface using the command "Configure". The configuration process is displayed at the bottom of the tab and lasts aproxapprox. 2 minutes. Detected modules will be added to the list of modules during the configuration process. After completing configuration the node returns to its normal operation. Sensors of detected CAN modules are added to the tree of elements.
...
If you need to remove CAN sensor module from the configuration list use command Delete, then use command "Save" to apply the changes you made and restart the node using the command Restart.
Child pages (Children Display)